Train stop

Train stop

Edit

Recipe
0.5 + 5 + 6 + 6 + 3 → 1
Total raw
8.25 + 7.5 + 14 + 3
Map icon
Health	250 325 400 475 625
Stack size	10
Rocket capacity	10 (1 stack)
Dimensions	2×2
Mining time	0.2
Prototype type	train-stop
Internal name	train-stop
Required technologies
Produced by

Train stops are used to automate item transportation by trains by providing nameable locations for trains to travel to.

Mechanics

Train stops are used to denote a place for a train to stop. Every placed train stop will appear as a possible stop in the scheduling area of a train's GUI. This can be used to create loading and unloading stations for trains.

Train stops with the same name count as the same "station", and trains will try to load balance themselves between the stops of the station. For example: Four trains are dispatched to "iron ore loading". There are two stops, both named "iron ore loading". Two trains would go to each stop. If there were two trains at one of the stops, then after the initial four trains had arrived there would be three trains at each stop.

As of 0.15, trains will attempt to avoid routes that pass through stations unrelated to their path.

Circuit Network

Train stops can be enabled or disabled using the circuit network. If a train is scheduled to go to a disable train stop, it will skip it and move to the next one (or route to an enabled train stop with the same name if one exists).

Additionally, train stops can be used to pass circuit signals to trains, or to read train contents.

Indicators

There are indicator lights on the top of the train stop. These show:

Permanently lit = The train stop is unoccupied/available.

Blinking alternately = A train is approaching or passing the train stop.

Blinking together = A train is stopped/occupying the train stop.

No lights = The train stop is invalid.

Blinking red = The train stop is disabled via circuit network.

Other uses

Map Marker

Until version 0.15.0, the only way to place a map marker was to use a train stop. A section of rail would be placed, then a train stop placed on the rail and the rail removed. The name of the train stop would appear on the map. As of 0.15, you can just click in the map screen to place a marker.

History

• 0.15.0:
  • Train station adds 2000 tiles penalty when path finding, so trains try to avoid stations not related to their path.
  • When the active train stop is removed trains will immediately leave the station if they're waiting at the station.

• 0.13.0:
  • New graphics
  • Placement indicator
  • Indicator of train position when stopped at station on hover.

• 0.10.0:
  • Station names can now be changed.

• 0.7.0:
  • Show the direction of incoming trains when being built.
  • Multiple train stops for each train station.

• 0.4.1:
  • Cannot be rotated after building.

• 0.4.0:
  • Introduced

See also

• Railway network
• Diesel locomotive
• Train